Home Up

ROLL TEC JR instructions

Assembly:  The Roll-Tec Jr was shipped with the handle removed.  This must be reattached prior to use.  Tighten the handle securely.   The die mounts onto the top of the plate with the two stud locating screws aligning into the die block.  The rubber faces up.  The cutting board sits on top of the die and covers all of the aluminum pins.

 

Operation:  Move the slide tray all the way towards either end.  The slide knob will touch the guard and stop.  Do not slam it into the guard.  Place the paper on the die with the edges against the pins.  Place the cutting board over the die, paper and pins.  Gently place your hand about center on the cutting plate.  While turning the handle guide the slide tray and die into the rollers.  The pinch rollers will carry the slide through the unit.  Stop turning the handle after the tray stops.  Move the slide further manually if required.  Remove the cutting board from the top of the die.  Some prints may stick to the board, remove them.  Carefully remove the prints and scrap from the die.   Do not press down because the die blade with be exposed and cut you.  Wipe off any debris on the cutting board before cutting another sheet.

 

Adjustment:  The cutter comes pre-adjusted from the factory.  If adjustment is required loosen the retaining nut and turn the screw to correct the problem.  Move the screw in small increments and test.  Repeat as required and tighten the nut.

Rotec Photo Cutters    313.535.1269

CAUTION :  BLADES ARE EXTREMELY SHARP