Home Up 15-C instructions

Roll-tec Computer Roll-tec 15 Roll-tec mini Roll-tec Jr Roll-tec 9

Roll-tec 9C or Roll-tec 15C

Roll-tec 9C electric computer controlled flat bed cutter   $2499.00 plus die and S&H
dies start at $150.00
       
size 8" X 13" x 28"   handles paper size up to 8-1/2" X 11" maximum

Roll-tec 15C electric computer controlled flat bed cutter   $2999.00 plus die and S&H
dies start at $150.00
       
size 8" X 17" x 42"   handles paper size up to 12" X 18" maximum

 

 

Easy operation:  Place cut product on die, lay cut plate on top and slide die and plate into the rollers.  The computer control
takes over and automatically starts and stops the cutter.  Cycle time is approximately 4 to 5 seconds.

 

    Dual roller drive for better feed

    Heavy duty cutting solution, no tedious hand cranking
    No operator fatigue from turning a crank handle thousands of times an hour

    Use the Roll-tec to texture prints, crease paper and more!

 

Cut Full sheet wallets and similar single sheets products.  CLICK ON SPECIALTY CUTS FOR SOME IDEAS ....Specialty Cuts

 Roller bearing transport system for slide tray
 Oversize aircraft quality aluminum drive rollers
 All aluminum main body construction, no plastic parts
 Heavy duty drive bearings
 Heavy duty chain drive motor system
 Quick and easy die change
 Dies can be made to order
 Baked enamel
 Hardened side guides
 Adjustable roller pressure screws 

 

Simple to use

  1. Turn main power on
  2. Place photo on die in between paper guides
  3. Place the cutting plate on top of the die and photo
  4. Slide die and plate in the direction you want to cut (the computer will handle the rest)
  5. Remove cutting plate and remove your pictures carefully

Hit Counter